PRECISION FINISHING SOLUTIONS. Spray Booths - Powder Booths - Custom Solutions. When you are looking to get the best and most-efficient finish for your job, no matter the product size nor the specific application, look no further than the consistently dependable, top-quality results from Rohner.
Enclose the booth in plastic. Lay plastic over enclosure so that the 25-foot (7.62-m) length is covering the longest dimension, 8-foot (2.44-m) width plus 6-foot (1.83-m) side walls. There will be leftover plastic that you can cut and use later as a strip below the fan. Leave enough plastic around the front of the booth to fold over and leave dangling to catch excess overspray (6 in / 15.24 cm should be fine). Wrap the remaining plastic over the rear of the paint booth to cover the rear. Leave room to add your fan(s). This is where the quick grip clamps are useful in holding the plastic in place. The plastic's weight should be enough to keep it from moving, but winds will easily push it off until the booth is complete.
- Apply duct tape while cutting the plastic sheeting, sealing off the sides of the enclosure. If your paint booth is installed in a windy area, make sure the plastic is tight against the PVC pipe. Use clamps to hold the plastic in place while you measure, cut, and place the duct tape.